What is continue command in matlab?

The continue command in MATLAB is used to skip the rest of the current iteration of a loop and move on to the next iteration. It is used within a loop to skip the remainder of the current loop iteration and move on to the next iteration, without terminating the loop.

For example, consider the following code:

for i = 1:10

  if i == 5

    continue

  end

  disp(i)

end

This code will print the numbers 1 through 4 and then 6 through 10, because the continue command causes the loop to skip the disp statement when i is equal to 5.

It is important to note that the continue command only skips the remainder of the current iteration of the loop, and does not terminate the loop. The loop will continue to execute until it reaches its stopping condition, unless it is terminated by another command such as break.